It is suitable for all load ranges, including peak load, and offers outstanding fuel flexibility: You can use low-calorific gases, gases containing CO₂, H₂S and N₂ or crude oil and other liquid fuels with high viscosity. In addition, it provides low NOₓ emissions, even in the part load range.
Highlights of the SGT5-2000E gas turbine
The SGT5-2000E offers dual-fuel capability and excellent fuel flexibility: It can be fired with low calorific gases or gases containing CO₂, H₂S and N₂, as well as with crude oil and other liquid fuels with high viscosity. The engine, equipped with DLE burners, is capable to burn up to 30 vol% of hydrogen (H2).
It provides reliable start-up and changeover between fuels. The automatic changeover from the primary to the secondary fuel can be carried out at reduced base load.
This robust engine is suitable for a wide range of ambient conditions such as cold climates, hot and dry or dusty environments. For hot and dry conditions, we offer these options to increase your power output:
- An evaporative cooler or an inlet air chiller with heat exchangers to avoid performance degradation
- A Wet Compression (WetC) system to enhance turbine performance by reducing compressor inlet temperatures and increasing the mass flow throughout the turbine
Ingenious design to the core
The SGT5-2000E core engine has a horizontally split casing and two walk-in combustion chambers, equipped with individually replaceable ceramic tiles. This design allows a hot-gas-path inspection without cover lift. The 16-stage axial-flow compressor with variable-pitch inlet guide vanes enhances peak load operation and supports frequency stabilization.
The robust 4-stage turbine incorporates the latest blade and vane design for stable, improved performance. The hybrid burners are able to operate in premix and diffusion mode with natural gas, fuel oil and special fuels such as heavy oil and refinery residues. With the Low-NOₓ combustion system, single-digit NOₓ emissions can be achieved.
Short installation times
The gas turbine package for the SGT5-2000E consists of the core turbine, the generator (SGen5-100A-2P) and auxiliary systems. We offer you a standardized basic design with options geared to your specific requirements. By using standard components and preassembly or prepackaging we achieve short installation times, with staggered delivery and early shipment of main components. We group subsystems and install them in separate auxiliary packages to minimize field assembly.
The SGT5-2000E fires up
We offer both simple cycle and combined cycle power plants with or without cogeneration.
SGT5-2000E-based combined cycle plants (SCC5-2000E) have a fast-start capability. You can achieve combined-cycle base load within less than 12 minutes for start-up until full load with a start-up gradient of 30 MW/min. High load gradients allow for fast load changes. With excellent peaking capability, and high part load efficiency complying with emission regulations down to lower part load, this is your profitable solution for competitive energy markets with fluctuating power demand.
Optimized for short outages to maximize availability
We offer Long Term Programs (LTP), overhaul services, field service, spare parts, reconditioning of components and modernization upgrades. Whether scheduled service or short-term support, our specialists are there for you, on-site all over the world.
The SGT5-2000E generator package is optimized for short outages. Multiple borescopic inspection ports allow inspection of compressor and turbine blades without lifting covers. The heat shields on the combustion chamber are individually replaceable. All stationary and moving blades and all stationary blade and vane carriers can be replaced individually with the rotor in place.
Fuel flexibility matters
The SGT5-2000E offers outstanding fuel flexibility: It burns natural gas, LNG, syngas, blast furnace gas, biogas, ethane, propane, condensate, distillate oil, heavy and crude oils, biodiesel, alcohols, naphtha or kerosene.
The gas turbine can also be fired with low-calorific gases or gases containing CO2, H2S and N2,or with up to 30 vol% of hydrogen (H2), as well as with crude oil and other liquid fuels with high viscosity.
Performance data for simple cycle power generation
NOₓ emissions at 15% O₂ on fuel gas (with DLE) at ISO ambient conditions.
SCC5-2000E: Performance data for combined cycle power plant
All combined cycle performance is based on 2 pressure, no reheat.